In a message dated 15/03/00 19:46:19 GMT Standard Time, sean@........... writes: > Difficulties with the stainless are that it is almost unsolderable; > if you epoxy the hinges, rough up the stainless with 600 grit emory. > I use the office paper cutter to cut it into narrow strips. Sean, If you use the proper stainless steel flux, EN58 austenitic stainless steel soft solders quite easily. The flux must be washed off thoroughly immediatly afterwards, as it is very corrosive. Regards Chris Chapman __________________________________________________________ Public Seismic Network Mailing List (PSN-L)
Larry Cochrane <cochrane@..............>