=20
Greetings all
 =20
     I received a new 'puter for Xmas so I moved all my networked =
'chines up a notch.
    I re-did all the networks ...etc....everything works great..
I can access all computers and their resources from each other.  The Two =
main ones I'm concerned about are SDR and Winquake (Original Machine =
names huh?) from sdr i can access Winquake and all it's files etc . I =
can write files, make new directories, delete files and =
directories.Everything seems as good as could be.
I have set up sdr to 'Net Use F: \\c209139b\quake_d'=20
( c209139b is the actual computer name on the network for the winquake =
machine. ) and it works fine

with sdr.ini set up to point all it's saved files to it's own hard drive =
everything works great. but if I set sdr.ini up to point to the Winquake =
machine all is not well..
sdr starts and runs normally for about 7 seconds then freezes, followed =
by having to reset the machine...

I am at having no luck from there... I have checked all IRQ's , =
addressing etc and there are no conflicts on both machines. SDR has only =
bare minimum boards
video, IDE/floppy/ser 1/network card/ and PCL 711
anyone have ANY suggestions?

thanks
tom







 
Greetings all
  
     I received a =
new 'puter=20
for Xmas so I moved all my networked 'chines up a notch.
    I re-did all the =
networks=20
....etc....everything works great..
I can access all computers and their=20
resources from each other.  The Two main ones I'm concerned =
about are=20
SDR and Winquake (Original Machine names huh?) from sdr i can access =
Winquake=20
and all it's files etc . I can write files, make new directories, delete =
files=20
and directories.Everything seems as good as could be.
I have set up sdr to 'Net Use F: \\c209139b\quake_d' =

( c209139b is the=20
actual computer name on the network for the winquake machine. ) and it =
works=20
fine
 
with sdr.ini set up to point all it's =
saved files=20
to it's own hard drive everything works great. but if I set sdr.ini up =
to point=20
to the Winquake machine all is not well..
sdr starts and runs normally for about =
7 seconds=20
then freezes, followed by having to reset the machine...
 
I am at having no luck from there... I =
have checked=20
all IRQ's , addressing etc and there are no conflicts on both machines. =
SDR has=20
only bare minimum boards
video, IDE/floppy/ser 1/network card/ =
and PCL=20
711
anyone have ANY =
suggestions?
 
thanks
tom