PSN-L Email List Message
Subject: Re: Lehman magnet/coil position
From: ChrisAtUpw@.......
Date: Thu, 3 Oct 2002 22:12:52 EDT
In a message dated 04/10/02, richg_1998@......... writes:
> By the way, where do you find 1/4 inch copper for the damping? I have
> everything but that. I do have 1/4 inch aluminum but I do not know if that
> will
> work. Any ideas?
Probably be OK. Soft Al is quite a bit better than Al alloy. I visited
a metal merchant to get an offcut of copper.
Chris
In a message dated 04/10/02, richg_1998@......... writes:
By the way, where do you find 1/4 inch copper for the damping? I have
everything but that. I do have 1/4 inch aluminum but I do not know if that will
work. Any ideas?
Probably be OK. Soft Al is quite a bit better than Al alloy. I visited a metal merchant to get an offcut of copper.
Chris
[ Top ]
[ Back ]
[ Home Page ]