Hi Chris

Thanks for the info. I did set the low pass cutoff freq to 4.5Hz (i
might have turned that setting off when you read this email, just to
compare the resaults), since most of the noise is above that level as
you say. But i wonder if i am right on doing that. The noise level is
alot less sinice i did move my geophone back in, execpt from the noise
from me and strong wind that was going on to night. It has been rather
flat line. I will need a earthquake to see if my low pass cutoff
settings are correct or not. I still detect the noise from my movements,
but at they are alot more lower then before.

I am looking into moving the geophone into my storage room, it can be
done. But not until i get a specal computer for it. Since i can't draw a
wire from that location and into my apartment. I will have to use wlan
and two winsdr to do this. Connected together over the wlan. If  that
can be done to start with.

Regards.
-- 
Jón Frímann Jónsson
http://www.jonfr.com

__________________________________________________________

Public Seismic Network Mailing List (PSN-L)