PSN-L Email List Message
Subject: RE: spike problem
From: =?ISO-8859-1?Q?J=F3n_Fr=EDmann?= jonfr500@.........
Date: Mon, 05 Jun 2006 23:45:36 +0000
Hi
> Have you connected the shield wire to the ground connection on the
board
yet?
No. I don't know where it is on the board. I've been trying to look for
it, but not found it.
I am going to have to buy a 330 ohm resistor. I know that if i
disconnect the geophone cable from the amplifer board. I get flat line
and no spikes at all.
> (All of your
> connections are soldered aren't they? If not, then do so.)
Connection inside the geophone are soldered properly. I have terminal
block screws on the amplifer board.
Regards.
--
Jón Frímann
http://www.jonfr.com
http://www.simnet.is/jonfr500/earthquake/
__________________________________________________________
Public Seismic Network Mailing List (PSN-L)
[ Top ]
[ Back ]
[ Home Page ]