PSN-L Email List Message
Subject: Re: Curved strip
From: ChrisAtUpw@.......
Date: Tue, 19 Feb 2008 12:05:11 EST
In a message dated 2008/02/19, charles.r.patton@........ writes:
> One possibility would be to find a flat piece of standard window pane,
> mount it, and provide tension screws to physically pressure it into the desired
> curve. After all it
> is only 0.001" in 1". I think glass would bend that much.
Hi Charles,
Much less than that. You specified a curve of 1000 ft, presumably the
radius.
If your strip is 6" long
Center deflection = (0.25)^2 / 2000 x 12 inches = 0.000375"
Regards,
Chris Chapman
In a me=
ssage dated 2008/02/19, charles.r.patton@........ writes:
One possibility would be to fin=
d a flat piece of standard window pane, mount it, and provide tension screws=
to physically pressure it into the desired curve. After all it
is only 0.001" in 1". I think glass would bend that much.
=
Hi Charles,
Much less than that. You specified a cu=
rve of 1000 ft, presumably the radius.
If your strip is 6" long
Center deflection =3D (0.25)^2 / 2000 x=
12 inches =3D 0.000375"
Regards,
Chris Chapman
[ Top ]
[ Back ]
[ Home Page ]