PSN-L Email List Message
Subject: Re: Tungsten Pins
From: "meredith lamb" paleoartifact@.........
Date: Tue, 10 Jun 2008 18:30:24 -0600
Excellent Dale!
Thanks so much for the salvage note! Hmmm....with summertime yard/garage
sales; one might pick up some quite cheap!
Of course their diameters could vary among the manufacturers, as well as the
lengths too. I think I'd even go "dumpster
diving" if I saw one therein; just to check out a machine.....ha.
Take care, Meredith Lamb
On Tue, Jun 10, 2008 at 5:10 PM, Dale Hardy wrote:
>
>
> The auction is for 50 of them <
> I use the shafts salvaged from capstan motors from VCR machines, they
> are Tungsten carbide approx 50mm long and 3mm diameter and Very highly
> polished ( mirror finish )
> Check your local electronics repairer ( if they exist in your area :) dying
> breed nowdays)
> Dale
>
>
Excellent Dale!
Thanks so much for the salvage note! Hmmm....with summertime yard/garage sales; one might pick up some quite cheap!
Of course their diameters could vary among the manufacturers, as well as the lengths too. I think I'd even go "dumpster
diving" if I saw one therein; just to check out a machine.....ha.
Take care, Meredith Lamb
On Tue, Jun 10, 2008 at 5:10 PM, Dale Hardy <
photon1@...........> wrote:
<there is none anywhere I know of that are ground and diamond
POLISHED. The auction is for 50 of them <
I use the shafts salvaged from capstan motors from VCR machines, they
are Tungsten carbide approx 50mm long and 3mm diameter and Very
highly polished ( mirror finish )
Check your local electronics repairer ( if they exist in your area :)
dying breed nowdays)
Dale
[ Top ]
[ Back ]
[ Home Page ]