PSN-L Email List Message
Subject: Re: Tungsten Pins
From: ChrisAtUpw@.......
Date: Tue, 10 Jun 2008 23:10:27 EDT
In a message dated 2008/06/10, paleoartifact@......... writes:
> Your techniques is a total unknown to me. How do you do your method/s?
Hi Meredith,
You use a copper TUBE which fits around the Tungsten Carbide rod. You
put diamond paste on the rod and use the copper to polish it. The diamond
chips bed into the copper surface by the pressure of the contact and they polish
the hard rod. You can also make a U of copper sheet bent around a drill shank
the same diameter as the rod and use diamomd paste to polish the rod. You can
fit the rod in a slow drill / lathe chuck to provide the rotation. I add oil to
the diamond paste to give a thick liquid. It is not difficult.
Regards,
Chris
In a me=
ssage dated 2008/06/10, paleoartifact@......... writes:
Your techniques is a total unkn=
own to me. How do you do your method/s?
Hi Meredith,
You use a copper TUBE which fits around=
the Tungsten Carbide rod. You put diamond paste on the rod and use the copp=
er to polish it. The diamond chips bed into the copper surface by the pressu=
re of the contact and they polish the hard rod. You can also make a U of cop=
per sheet bent around a drill shank the same diameter as the rod and use dia=
momd paste to polish the rod. You can fit the rod in a slow drill / lathe ch=
uck to provide the rotation. I add oil to the diamond paste to give a thick=20=
liquid. It is not difficult.
Regards,
Chris
[ Top ]
[ Back ]
[ Home Page ]