PSN-L Email List Message
Subject: Re: Tungsten Pins
From: ChrisAtUpw@.......
Date: Wed, 11 Jun 2008 00:56:09 EDT
In a message dated 2008/06/11, paleoartifact@......... writes:
> One more question. Can the copper tube ID be slightly larger than the
> carbide OD; or, is it not even that critical?
Hi Meredith,
It is not too critical, easier if the Cu tube is not a close fit.
I can buy syringes labelled Fine, Medium and Coarse. The coarse gives
good results and you can then use another bit of Cu tube with the Medium to
finish / polish it.
Regards,
Chris
In a me=
ssage dated 2008/06/11, paleoartifact@......... writes:
One more question. Can th=
e copper tube ID be slightly larger than the carbide OD; or, is it not even=20=
that critical?
Hi Meredith,
It is not too critical, easier if the C=
u tube is not a close fit.
I can buy syringes labelled Fine, Mediu=
m and Coarse. The coarse gives good results and you can then use another bit=
of Cu tube with the Medium to finish / polish it.
Regards,
Chris
[ Top ]
[ Back ]
[ Home Page ]