How would the "wire" actually be setup or configured physically in the 
"standard" Lehman.   Ed.


----- Original Message ----- 
From: "Brett Nordgren" 
To: 
Sent: Sunday, June 06, 2010 11:03 AM
Subject: Re: Wire Strength


> Geoff,
>
> Try    http://www.smallparts.com/   and search for "17-7 PH Spring Wire"
>
> As sold, in "Condition C" it has a yield strength of over 190,000 psi
> and if you want to bake it for an hour at 900 F you can raise that to
> 260,000, and it will possibly get even higher than that.  The 17-7
> material we use for leaf springs gets a yield strength close to
> 300,000 psi after baking.
>
> The material property you want to be looking at is yield
> strength.  As defined by AK Steel
> corp.
> http://www.aksteel.com/pdf/markets_products/stainless/precipitation/17-7_PH_Data_Sheet.pdf
> it is the stress level at which the material will permanently stretch
> by 0.2%.  You could stress a wire to half that value reasonably safely.
> In some places yield stess is defined at 2% or even 5% permanent
> stretch, so you should be aware of which one is being used.  In any
> case, working at 40-50% of yield is likely to be OK.
>
> Brett
>
>
> At 02:30 AM 6/6/2010, you wrote:
>>Does anyone understand wire strength ?
>>
>>I will look at this way.
>>
>>HY80 steel has the ability to stand up to
>>80,000 lb/in^2 so you just translate
>>say the area of a given steel wire
>>what it would be if whatever weight
>>was on that area as translated to
>>the area of the wire guage then if it is
>>like 1/2 the yield strength 40,000 lb/in^2 you should be ok ??
>>
>>5 lb on a 28GA wire might translate to
>>Diameter => 2*SQR(weight/(PI * 40000))
>>Where HY80 type steel is the wire steel ?
>>Maybe 28 or less AWG steel wire. (you need an AWG table)
>>
>>If it were piano wire it might be HY160
>>or something better than plain steel ?
>>
>>IS there such a thing as stainless steel wire
>>or something that will not corrode/rust ?
>>
>>Does any of that sound right ?
>>
>>I think like a LAYMAN and not Lehman :-)
>>
>>Thanks ahead of time,
>>geoff
>
>
> __________________________________________________________
>
> Public Seismic Network Mailing List (PSN-L)
>
> To leave this list email PSN-L-REQUEST@.............. with
> the body of the message (first line only): unsubscribe
> See http://www.seismicnet.com/maillist.html for more information.


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.437 / Virus Database: 271.1.1/2920 - Release Date: 06/05/10 
18:25:00

__________________________________________________________

Public Seismic Network Mailing List (PSN-L)