Hello PSN folks,

Below Is A Velocity Sensor i had sitting
in the corner for the past few years
which has collected a lot of dust.

"Please Excuse the Years of dust and, possibly, life forms present"

I believe it to be a proper design
for motion along the plane of the faces
of the two magnets.

The poles are N=>S TOP
                     S=>N Bottom

I intend the coil to move vertically in this picture.

http://gmvoeth.home.mchsi.com/100_0516.jpg

Do any of you know for sure if this is
or is not the correct use of magnet and coil
as a sensor ?

Please explain your response so I "MIGHT" understand.

Best regards,
geoff


__________________________________________________________

Public Seismic Network Mailing List (PSN-L)