Hi Gary I don't know if this is the same symptom as you were describing but I have had GIF problems in the past when I was asking my computer to do to much at once. I was recording 8 channels @ 50 hz. I could only create GIF files for 12 hrs on 2 channels. Anything more than that and I would get a GIF error message. I don't remember the exact text. The GIF displays would have the wrong times or dates. The way I got this corrected for me was to stop winsdr and restart it, This seemed to correct my problem Regards Barry http://www.seismicvault.com ________________________________ From: Gary LindgrenTo: psnlist@.............. Sent: Wed, September 29, 2010 3:05:19 PM Subject: GIF End Flag Error in dspHistFile Hi All, All of a sudden this AM I noticed in the WinSDR log file that I have a GIF End Flag Error in dspHistFile. The data is not being displayed correctly. Whenever I change the Channel from one channel to another I first see the 24 hours of data displayed momentarily then screen goes white and only displays the data that is then recorded. Just like I have a new copy of WinSDR. Is there any way to correct this. I can't use WinSDR now. Gary Gary Lindgren 585 Lincoln Ave Palo Alto CA 94301 650-326-0655 www.blue-eagle-technologies.com Check out Lastest Seismometer Reading cymonsplace.blogspot.com sites.google.com/site/seismicsensorinfo/Home Design Details for New Vertical Hi Gary
I don't know if this is the same symptom as you were describing but I have had GIF problems in the past when I was asking my computer to do to much at once. I was recording 8 channels @ 50 hz. I could only create GIF files for 12 hrs on 2 channels. Anything more than that and I would get a GIF error message. I don't remember the exact text. The GIF displays would have the wrong times or dates. The way I got this corrected for me was to stop winsdr and restart it, This seemed to correct my problemRegards
Barry
http://www.seismicvault.com
From: Gary Lindgren <gel@.................>
To: psnlist@..............
Sent: Wed, September 29, 2010 3:05:19 PM
Subject: GIF End Flag Error in dspHistFile
Hi All,
All of a sudden this AM I noticed in the WinSDR log file that I have a GIF End Flag Error in dspHistFile. The data is not being displayed correctly. Whenever I change the Channel from one channel to another I first see the 24 hours of data displayed momentarily then screen goes white and only displays the data that is then recorded. Just like I have a new copy of WinSDR. Is there any way to correct this. I can't use WinSDR now.
Gary
Gary Lindgren
585 Lincoln Ave
Palo Alto CA 94301
650-326-0655
www.blue-eagle-technologies.com Check out Lastest Seismometer Reading
sites.google.com/site/seismicsensorinfo/Home Design Details for New Vertical Seismometer
[ Top ] [ Back ] [ Home Page ]