PSN-L Email List Message
Subject: Re: time sync to WinSDR
From: Thomas Dick dickthomas01@.............
Date: Thu, 02 Feb 2012 12:07:03 -0600
On 2/2/2012 12:01 PM, Stephen Hammond wrote:
> Recently I thought my Oncore stopped working and found that the ground
> shield on the antenna wire was pulled apart. No grounded ground shield --
> no work-- Regards, Steve Hammond
>
> -----Original Message-----
> From: psnlist-request@.............. [mailto:psnlist-request@...............
> On Behalf Of Larry Cochrane
> Sent: Thursday, February 02, 2012 12:56 AM
> To: psnlist@..............
> Subject: Re: time sync to WinSDR
>
> Tom,
>
> My guess is you have a bad active antenna or the ONCORE receiver itself has
> failed. I
> would check that the antenna is correctly connected to the receiver and if
> that's ok
> move the antenna to a different location.
>
> Regards,
> Larry Cochrane
> Redwood City, PSN
>
> On 2/1/2012 2:29 PM, Thomas Dick wrote:
>> The last two weeks or so the WinSDR is showing an "N" the whole 24 hrs.
>> The timing unit is an Oncore unit (from Larry). At first, I thought it
>> was sunspots but there is no lock even in the dead of night. Anyone have
>> this proble?
>> __________________________________________________________
>>
>> Public Seismic Network Mailing List (PSNLIST)
>>
>> To leave this list email PSNLIST-REQUEST@.............. with
>> the body of the message (first line only): unsubscribe
>> See http://www.seismicnet.com/maillist.html for more information.
>>
In retrospect, I suspect the break is where the cable goes into the
antenna. I had attached it to a post with plastic tape and I think the
vibration in the wind finally did it in
__________________________________________________________
Public Seismic Network Mailing List (PSNLIST)
To leave this list email PSNLIST-REQUEST@.............. with
the body of the message (first line only): unsubscribe
See http://www.seismicnet.com/maillist.html for more information.
[ Top ]
[ Back ]
[ Home Page ]