Date: Mon, 24 Dec 2001 16:04:19 -0800 From: Larry Cochrane <cochrane@..............> Subject: Re: WinSDRDick,
On both the DB9 and DB25 the transmit and receive lines are on the same pins 2 and 3. Just make sure they are swapped. The ground on the DB25 is pin 7 and on the DB9 pin 5. So pin 5 on the DB9 should go to pin 7 on the DB25 connector and pin 2 on the DB9 should go to pin 3 on the DB25 and pin 3 to pin 2.
-Larry
At 06:54 PM 12/24/2001 -0500, you wrote:
Larry,.
The cable I am using has a DB9 AND a DB25 on each end of the cable. I looked at Tommy's connector page but could not find the db9 connector. What should be the correct pins for the Return, Transmit and GND.
Dick
At 02:27 PM 12/24/01 -0800, you wrote:
Dick,
WinSDR will run fine under NT. Karl is running it under NT and I use Win2K. Win2K is very similar to NT. I would double check your RS-232 cable. The GPS receiver connects up to the sdrservr system not the WinSDR computer.
Regards,
Larry
At 05:00 PM 12/24/2001 -0500, you wrote:
Hi and Merry Christmas to all!
Does WinSDR run under NT? I have installed it on a laptop running NT. The sdrservr is on a dos machine. I am not getting any communication and have tried all available port settings. Also, should the GPS be hooked to the WinSDR or the sdrservr computer? I am using a Belkin file transfer serial cable that has a crossed null-modem wiring design.
Dick
__________________________________________________________
Public Seismic Network Mailing List WinSDR
To leave this list email WINSDR-REQUEST@.............. with the body of the message (first line only): unsubscribe
__________________________________________________________
Public Seismic Network Mailing List WinSDR
To leave this list email WINSDR-REQUEST@.............. with the body of the message (first line only): unsubscribe